Table of Contents
Advertisement
D*AP8
Reversion Program
Program Config.
Reversion Preset
Program x
Important Note! There is only one set of reversion presets for all programs. You must be careful when you
assign reversion presets to programs. It may be a good idea to name the presets used for reversion mode
after the program number it is meant for.
Setup GUI – DOLBY PROCESSING – Metadata – Program x
Metadata Generator
Generator
Program Config.
Current
Program Config.
Frame Rate
Generator used for
Emulation (depends
on Decoder Setup)
Reversion
Metadata Reversion
Status
Metadata Reversion
Mode
[5.1+2, 4 x 2, 3 x 2]
Pre-selection of the program configuration for reversion mode.
You can select a preset for Program x to become the
Reversion preset for that program.
51
[Follow Input / 5.1+2 / 4 x 2 /
5.1 / 3 x 2]
displays the actual program
configuration used by the
generator.
display of the frame rate
SYSTEM > Setup >
Video Rate (fps).
[OFF / ON]
shows if the generator is
used for emulation or not.
[Normal / Reversion]
Display of the reversion
mode status.
[Last Valid / Preset]
Selection of what happens in
case of input metadata
failure.
Advertisement
Table of Contents
