Table of Contents
Advertisement
Setup GUI – EVENTS – Overview
The D*AP8 offers a sophisticated event management system.
The event management system performs Actions. These Actions are built from Events.
Actions may be triggered manually (via the X*AP RM
(triggered by network commands or GPIs) and automatically (triggered by changes of parameters and/or
the internal status) or as a combination of all three.
The overview shows the building blocks of the EVENTS system of the D*AP8. The examples further below
are taken from the actual set of factory pre-set events based on a number of useful presets:
A trigger is subdivided into a trigger type and a trigger source. E.g. a GPI is a trigger type while its
number (the physical input) represents the trigger source. Other trigger types have sources which must
be configured, like the names of X*AP Hotkeys or network triggers.
Hotkey Sources
Network Sources
Parameter Sources
The triggers will be defined by its trigger equation that may be the logical combination of 2 trigger
sources.
The D*AP8 knows five different event types:
Preset Events (Profiles)
Parameter Events
Measurement Events
I/O Events
Bypass Events
remote panel Hotkeys), semi-automatically
1
You may assign hotkeys of the X*AP remote and / or the mobile UI
to become a trigger source.
Received via the l-s-b EmBER+ protocol.
Device parameters / status information grouped into
systems and Interfaces.
System / Interfaces / Routing / Dolby Processing /
Audio Processor / Programs / AUX / Delay / Monitor / Measurement
System / Measurement
Loudness 4 x 2 / Loudness 5.1 + 2
GPOs
Programs / AUX
86
D*AP8
Advertisement
Table of Contents
