Getting Started - Basic X*Ap Rm1 Remote Panel Operation; Operating - Menu Structure Of The X*Ap Remote Panel - Operating Displays - junger D*AP8 FLX Manual

Getting started – basic X*AP RM
Power up display – may show up to four D*AP8s enabled for remote control for this X*AP RM
remote panel. This example has just one D*AP8 named "NEWS Channel" attached for remote control
while the status is "connect" (i.e. you may connect with that device). See X*AP RM1 manual for details.
Remote Panel select device to control
News Channel
10.110.92.180
connect
Pressing one of these buttons will connect with the respective D*AP8.
Now the X*AP RM
1
(may take a few seconds) and open up the main operating display:
EBU Program 1
S
-22.5
out
R128 ITU1770
From here you may fire pre-defined hotkeys and observe the status of the volume setting.
Because this is the main operating display, the escape button will light up
display is below the main operating display. Pressing
(device selection).
The hot keys may be programmed by the administrator of the device to recall global settings
(see EVENT management for details) and therefore may have dedicated names.
Operating – menu structure of the X*AP RM
Important Note! The functions described below expect a proper routing of the signal from hardware
interfaces to the audio processor and back (see ROUTING pane).
When pressing the <MENU> button, the main page of the operating menu opens up:
Menu
Audio
Processor
This menu allows for high level selections like the control of the audio processor or showing the meter
display.
remote panel operation
1
remote panel will gather all necessary information from that D*AP8
LUFS
Loudn Lim
D02
remote panel – operating displays
1
News Channel
EBU R 128
Meter
Program 2
-23.0
LUFS
Nicerizer
Limiter! [Panic 1
red
<ESC> returns you back to the power up display
10.110.92.180
10
D*AP8
1
MENU
MENU
Panic 2]
to indicate that the power up
MENU
ESC
ESC
ESC