Table of Contents
Advertisement
D*AP8
Setup GUI – INTERFACES – Dante I/O Interface – Outputs
Setup GUI – INTERFACES – Dante I/O Interface – Network
Dante Redundancy
Outputs
Channel
Channel
Label
The Dante interface allows redundant network operation.
Pls. refer to manufacturer's documentations of your Ethernet
equipment on supported redundant operation.
39
The signals from the Dante
board to the network. They will
also appear in the device
ROUTING section.
Numeric count of the channels.
Up to 16 labels can be assigned
for each stream from the
interface to the network.
When you hover with the mouse
over the channel labels, you will
get a tool tip that that shows the
other (if any) labels assigned to
the same outputs assigned fro
multi layer routing.
Advertisement
Table of Contents
