Table of Contents
Advertisement
Important note! The AES relay bypass circuit of the AES I/Os may be deactivated inside the
D*AP8. You must open the cover plate from the D*AP8 unit and locate the red jumpers shown in the
schematic below:
You must remove the jumper to de-activate the respective AES I/O relay power fail circuit.
Setup GUI – INTERFACES – SDI I/O interface – Overview
If the D*AP8 is equipped with an optional SDI interface the following settings will be available.
This pane has five sub panes embedded:
The overview pane shows all relevant information of that interface:
SDI Status
Video Format
Video Standard
Audio De-Embedder
Status
VANC Metadata
De-Embedder Status
Audio Embedder
Status
[Locked / Unlocked]
[SD / HD /3G / N/A]
[actual decoded standard (e.g. 1080i50) / No SDI Lock]
[PCM / Dolby E / Dolby Digital / Dolby Digital Plus / MPEG-4 HE AAC /
MPEG-4 AAC / N/A]
The respective soft LED will turn green to indicate the SDID found in the stream
while the angle brackets indicate the SDID one has selected in the de-embedder
set-up as a pre-selected stream.
[AUTO – Embedding / AUTO – Replace Audio / OFF / Delete]
28
D*AP8
Advertisement
Table of Contents
