Table of Contents
Advertisement
D*AP8
The D*AP8 has two different action types:
Event Actions
Bypass Actions
An action runs like a flip-book inside the D*AP8. This powerful technology spans from simply
recalling a certain system parameter over speaker or Dolby specific parameter combinations
(household name: "Preset") to the complete reconfiguration of the D*AP8 including all signal routing,
processing parameters and so forth. It allows you to create your own snap shots where you decide
what is part of it and what is not! But it also enables several fail over scenarios where the D*AP8 will
automatically react to the system and/or parameter status.
The steps to set up the EVENTS system are as follows:
1.
Define
2.
Configure
3.
Set up events
4.
Create actions
Setup GUI – EVENTS – Triggers – Sources – Remote Hotkeys
Hotkeys are the eight buttons of an X*AP RM
to become active on the X*AP RM
Mobile Options
<remove>
The number of hotkey triggers is not limited. You may also add virtual hotkeys which can be used by a
graphical UI for example that may have more than 8 compared to the X*AP RM
executes the predefined events
executes pre-defined bypass scenarios, independent of
the bypass events
- trigger sources
- triggers by logical combination of the pre-defined trigger sources
- by selecting presets for function blocks
- what will happen - which trigger will launch which event? Or what will happen
in case someone presses the <BYPASS> button at the X*AP RM
engages the <Force Trigger Active> check box
> Actions > Bypass Action)
(see EVENTS
remote panels main operating menu:
1
The buttons of the Mobile UI can be assigned an individual color.
You will see the bright color if the button is active and the dark color
if it is inactive. [OFF/Divider] acts as a place holder for a button that
is temporarily set to OFF.
will remove a line from the list. This will automatically disable the
respective front panel button.
.
remote panel. You may give them names and enable them
1
<add trigger> You can add lines here.
#
Label
X*AP Remote [ON / OFF]
87
or
1
The number of the Hotkey on the
X*AP RM
remote panel, counting
1
from left to right.
Each Hotkey may have a label that
appears in the display of the
X*AP RM
remote panel above that
1
button.
If you un-check, the respective
Hotkey on the X*AP RM
panel becomes inactive - no label is
displayed and the button
background light turns off.
.
1
remote
1
Advertisement
Table of Contents
