Table of Contents
Advertisement
Interface 1
Firmware
Status
Update Firmware
Interface 2
Slot A
<reset dolby decoder /
e-encoder (cat1100)>
Slot B
<reset coprocessor
jdspa)>
Licensing
<save license info>
Load License File
Setup GUI – SYSTEM – Reboot
Restore Factory defaults
Overwrite Current IP
IP Configuration
SDI/O
You may also update the firmware of an optionally installed SDI board
or other interface boards.
Display of actual installed firmware.
[The latest firmware is installed. /
[Load External File / x.y.z.]
You can decide if you want to upload it manually or take the latest
module firmware "x.y.z" that came with the release image
(recommended). You may <Browse...> the file system and select a file
of your choice.
If you have two interface boards installed, similar applies to the second
one.
Dolby Decoder / E-Encoder (CAT1100)
For the example above we have the optional Dolby decoder installed.
It is based on the Dolby OEM board CAT1100.
The status says: "The latest firmware is installed".
Pressing this soft button will warm start that module.
Coprocessor (JDSPA)
For the example above we have the optional Coprocessor installed.
It is based on the JDSPA module.
Pressing this soft button will warm start that module.
Here you can see a list of the licensed options of the D*AP family.
When you buy a license you must provide the "license info" file which
you may obtain here.
In return you will get a "license" file which you must apply to the device
here. You must <Browse ...> to find the respective license file (which
you have unzipped before) and press <apply new license>.
Will clean up the parameter and preset memory and will initialize all
parameters to their factory default values and will reset passwords
and turn authentication off.
You may exclude the current IP settings from this process
to keep your existing settings.
26
A firmware update is
available]
D*AP8
Advertisement
Table of Contents
