junger D*AP8 FLX Manual page 56

Above you can see the input metadata of the processor and you can decide about the metadata output.
You may set it to follow the input or you may overwrite it. The table shows the most relevant metadata.
The Expert checkbox gives you access to more specific metadata:
Important Note! Dolby advises that the RF Overmodulation Protection must be off. Therefore Junger
automatically turns it off. You are not able to set this parameter and no <Follow Input> check box exists,
except for the preset parameters which will be ignored when loading it.
If Emulation is active and the option
the metadata are used for emulation are highlighted by a yellowish background:
This example shows the metadata from Program 1 of a Dolby E encoded stream.
"MD Generator overwrites encoded Metadata" is turned on,
52
D*AP8