Table of Contents
Advertisement
D*AP8
Select item "8: Reboot" <ENTER>
Do you want to reboot the device ?
Press small "y" <ENTER>
Rebooting the device ........
After reboot has finished, the new IP configuration is active and will be displayed at the top of the
configuration menu.
Getting started – IP setup of the D*AP8
* Read the default IP address printed on a label at the rear of the device.
* Set up network parameters of your PC to fit the default IP address of the D*AP8 unit
(e.g. default IP + 1 and net mask = 255.255.0.0).
* Connect the D*AP8 with the PC either via an Ethernet patch cable (if the PC
supports Auto-MDI(X), an Ethernet cross over cable or via patch cables with a switch.
* Open a browser and type the IP address of the D*AP8 into the URL field and press <ENTER>.
This will open the AUDIO PROCESSOR tab sheet of the GUI.
* Click on <SYSTEM> and afterwards the <Admin> tab:
Enter the desired network configuration and press <apply>
Afterwards you must reboot the D*AP8 in order to activate the new IP configuration.
Important Note! After reboot neither the web browser nor the X*AP RM
communicate with the D*AP8 unit. You must fill in the new IP address in the URL field and change
the X*AP RM
remote panel settings to attach this device with its new IP address.
1
via web browser
–
9
remote panel will be able to
1
Advertisement
Table of Contents
