MADI Transmitter
Transmitter Channel Count
Transmitter Channel Status
Channel Mapping @ 96 kHz
The connection for fiber cable is made by a LC connector. Looking at the rear panel the transmitter is
the left one and the receiver the right one.
Setup GUI – INTERFACES – MADI Interface – Local Routing
Below are some excerpts from the local routing pane. Single channels from or to the D*AP8 may be
connected with the MADI transmitter or MADI receiver respectively.
The example below shows the first eight MADI channels from the receiver (MADI RX 1 ... MADI RX 8)
connected with the device inputs SYSTEM - MADI INPUT (MDIN 1 ... MDIN 8):
The Local Routing pane can also be used to route MADI signals from the receiver directly to the
transmitter and vice versa:
[64 (32) / 56 (28)]
Depends on the internal sample rate and the desired number of
MADI channels. The numbers in brackets are valid for 96kHz.
[Transparent / Professional]
[Normal]
34
D*AP8