Setup Gui - Audio Processor - Fail Over (4 X 2 Program Configuration) - junger D*AP8 FLX Manual

setup GUI – AUDIO PROCESSOR – Fail Over (4 x 2 program configuration)
For the 4x2 Program Configuration (SYSTEM > Setup > Program Configuration) the D*AP8 offers
four independent Fail Over circuits (see Overview sketch).
The source for the Fail Over circuit can be either the adjacent program input (e.g. input 2L/R for the
program input 1L/1R) or the AUX input. The Mode switch will select the respective signal path.
See the example above for the four program outputs :
program 1 (1L/1R)
program 2 (2L/2R)
program 3 (3L/3R)
program 4 (4L/4R)
Fail Over 1L/1R
MODE
has a valid input signal and is prepared for auto switch over
to the second program input 2L/2R.
has no valid input and has automatically switched over
to the AUX input.
has a valid input and is prepared for auto switch over
to input 4L/4R, input 4L/4R has valid input.
This is indicated by the yellow soft LED.
is fix connected to AUX. Signal input is mono L.
Example description of the fail over function blocks
62
The Fail Over output can be permanently
connected to:
* its program input 1L/1R
* its adjacent program input 2L/2R
* or to the AUX input.
Automatic switch over in case of an input
failure may be configured for the AUX or the
adjacent 2L/2R input.
D*AP8