Table of Contents
Advertisement
D*AP8
Setup GUI – connecting with the D*AP8 – AUDIO PROCESSOR > Overview
You must open a browser and enter the IP address of the D*AP8 unit
into the URL field
and press <Enter>. The browser will fetch the necessary information and open the
entrance page:
The entrance page is the AUDIO PROCESSOR pane with its sub pane Overview. If you are returning from
other pages or if you reload your browser content by pressing <F5> it may show a different page due to
caching of the browser.
In the top area you have several bar graph displays for IN/OUT peak level of the audio processor, the AUX
input and the Monitor output. A numeric display of loudness measurement and other bar graphs to display the
gain changes of the function blocks: expander, compressor leveler and limiter complement upper display.
On the following pages we will go through the various panes to perform the basic setup of the device.
You must setup the synchronization source. You may also give the device a name, tell it its location and
define an administrative contact which may be used by monitoring systems of your company (e.g. via SNMP).
You must setup the installed interface modules and finally set the signal routing. Those settings you will find
under the SYSTEM link.
14
Advertisement
Table of Contents
