Table of Contents
Advertisement
D*AP8
Setup GUI – INTERFACES – AES I/O
Status
Input Signal Status
Input Signal Type
Important Note! The input signal status is logically combined and represented as part of the
System Status. If one of the inputs is not assigned by the ROUTING matrix, its status will not be
incorporated into the System Status. If non of the inputs is routed the Interface Status > AES I/O status soft
LED becomes grey.
Settings
Enable Relay Bypass
Input Sample Rate
Converter
Output Channel Status
[green / red / yellow] The soft LED represents the status
[OK / Fail]
Fail = no carrier, unlock, cranky [too much jitter]
[Mute / PCM / Non PCM]
The Non PCM (e.g. Dolby encoded signal) status will be retrieved
from a logical combination of the Validity flag and the channel
status.
[ON / OFF]
For fail save operation bypass relays are provided to connect
AES IN / OUT in case of a power fail. One may enable such relays
manually here.
[ON / OFF]
For asynchronous sources it is possible to turn a SRC on.
If an SRC is turned on and the input status becomes Non-PCM, the
SCR will be turned OFF automatically in order to maintain the
original data structure of the encoded bit stream (e.g. Dolby E).
[Transparent / Prof PCM / Prof Non-PCM / Cons PCM /
Cons Non-PCM]
The channel status can either be transparent from the
input source of the D*AP8 or may be overwritten.
27
Advertisement
Table of Contents
