Table of Contents
Advertisement
You must use the scroll bar to navigate through the matrix. In the upper left corner you can select between
the ONAIR and the PRESETS view of the matrix. On the ON AIR page you will also see the device signal
labels (see ROUTING section further below for details).
Channel Linking
You may select cross points by hovering with the mouse over the little squares and select / deselect cross
points with a left mouse button click. The color of the respective squares changes:
Mouse over
dark blue
orange
grey
red
An animated signal flow
Setup GUI – INTERFACES – SDI I/O interface – Setup
[mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
Color codes of cross points:
Possible new cross point.
You are about to reconnect a cross point.
Cross point is not allowed (i.e. routing will cause a loop and will not
therefore be performed) or dedicated input is not activated.
You are about to disable a cross point
will help you when navigating through the matrix.
SDI Bypass
SDI Relay Bypass Will deactivate the Bypass
SDI Embedder
Bypass
Video Delay
Video Delay
(frames)
30
D*AP8
Relay. It provides a shortcut from
SDI-IN to SDI-OUT1 and
disconnects the de-embedder
from the SDI input. This relay
also serves as a fail bypass if
the power is off. This feature
maintains the SDI signal for
downstream equipment.
Will pass the embedded audio
data from the de-embedder to the
embedder 1:1. This function
preserves the original
Ancillary Data structure.
[0 ... 15]
For compensation of any kind of
audio processing delay within the
chain of devices you may use a
Video Delay. Position "0" turns
off the delay function.
Advertisement
Table of Contents
