Setup Gui - Events - Triggers - Sources - Remote Hotkeys; Setup Gui - Events - Events - Preset Events (Profiles) - junger D*AP4 VAP Edition Manual

Voice audio processors
Table of Contents

Advertisement

The D*AP4 VAP has two different action types:
Event Actions
Bypass Actions
An action runs like a flip-book inside the D*AP4 VAP. This powerful technology spans from simply
recalling a certain parameter over narrator specific parameter combinations (household name: "Preset")
to the complete reconfiguration of the D*AP4 VAP including all signal routing, processing parameters
and so forth. It also allows you to create your own snap shots where you decide what is part of it and
what is not! But it also enables several fail over scenarios where the D*AP4 VAP will automatically
react to the system and/or parameter status.
The steps to set up the EVENTS system are as follows:
1.
Define
2.
Configure
3.
Set up events
4.
Create actions
Setup GUI – EVENTS – Triggers – Sources – Remote Hotkeys
Hotkeys are the 8 buttons of an X*AP RM
to become active on the X*AP RM
The number of hotkey triggers is not limited. You may also add virtual hotkeys which can be used by a
graphical UI for example that may have more than 8 compared to the X*AP RM
executes the predefined events
executes pre-defined bypass scenarios, independent on
the bypass events
- trigger sources
- triggers by logical combination of pre defined trigger sources
- by selecting presets for function blocks
- what will happen - which trigger will launch which event? Or what will happen
in case of some one presses the <BYPASS> button at the X*AP RM
engaging the <Force Trigger Active> check box or ignite an action from the
mobile UI.
remote panel. You may give them names and enable them
1
remote panels main operating menu:
1
<add trigger> You can add lines here.
#
The number of the Hotkey on the
X*AP RM
from left to right.
Label
Each Hotkey may have a label that
appears in the display of the
X*AP RM
button.
Enable
[ON / OFF]
If you turn it off the respective
Hotkey on the X*AP RM
panel becomes inactive - no label is
displayed and the button
background light turns off.
<remove>
will remove a line from the list. This
will automatically disable the
respective front panel button.
68
D*AP4 VAP
or is
1
remote panel, counting
1
remote panel above that
1
remote
1
.
1

Advertisement

Table of Contents
loading

Table of Contents