Table of Contents
Advertisement
Transmit Metering Data
Service Options
Maintenance Interface [OFF / ON]]
via RPC
Telnet Server
Diagnostics
<get diagnostics file>
Setup GUI – SYSTEM – Setup
Voice Channel Mode
Important Note! If set to "Stereo" all relevant settings will provide an unlink function in case you need to
setup both channels differently for any reason. I.e. the layout of several panes and the X*AP RM
depending on this setting. If put into "Stereo" mode the label for Voice 1 (see below) will be used.
Section / Channel Labels
Voice 1
Voice 2
Program
[OFF / ON]
Metering data will be streamed via UDP protocol. In order to receive such
data by external applications you must enable it.
For administrative use to enable communication with factory tools.
[ON / OFF]
Enables a telnet server to connect the consol interface via IP (port 21).
Pressing this soft button will start the assembly of a diagnostics file.
The file will be presented in XML format for download.
If you experience unexpected behavior of the device you may be asked by
the Junger support team to send such file by e-mail for analysis.
[2 x Mono / Stereo]
Set according to the type of voice signal. This will automatically
configure all relevant audio processing blocks.
Each of the individual voice channels as well as the program path
has a name that will be used as a reference for the display of
parameters and their setup. You may use names of your choice.
Default names are Voice 1 / Voice 2 and Program.
18
D*AP4 VAP
will differ
1
Advertisement
Table of Contents
