Table of Contents
Advertisement
MADI Transmitter
Transmitter Channel Count
Transmitter Channel Status
Channel Mapping @ 96 kHz
The connection for fiber cable is made by a LC connector. Looking at the rear panel the transmitter is
the left one and the receiver the right one.
Setup GUI – INTERFACES – MADI Interface – Local Routing
Below are some excerpts from the local routing pane. Single channels from or to the VAP may be
connected with the MADI transmitter or MADI receiver respectively.
The example below shows the first 8 MADI channels from the receiver (MADI RX 1 ... MADI RX 8)
connected with the device inputs SYSTEM MADI INPUT (MDIN 1 ... MDIN 8):
The Local Routing pane can also be used to route MADI signals from the receiver directly to the
transmitter and vice versa:
[64 (32) / 56 (28)]
Depends on the internal sample rate and the desired number of
MADI channels. The numbers in brackets are valid for 96kHz.
[Transparent / Professional]
[Normal]
34
D*AP4 VAP
Advertisement
Table of Contents
