Table of Contents
Advertisement
D*AP4 VAP
Setup GUI – INTERFACES – AES Interface – Status / Setup
An additional AES3 interface can be installed in the Interface slot.
It provides 4 additional AES3 inputs and outputs on a 25pin D-Sub connector:
Status
Input Signal Status
Input Signal Type
Settings
Enable Relay Bypass
(All Channels)
Input Sample Rate
Converter
Output Channel Status
Important note! The AES relay bypass circuit of the I/Os is activated on the option board. It is possible to
deactivate it if necessary. You must open the cover plate of the D*AP4 VAP unit and locate the jumper
shown in the schematic below. You must remove the jumpers
power fail circuit.
green [OK] / red [Fail]
[Mute / PCM / Non PCM]}
[ON / OFF]
Power fail bypass relay that may be activated by the GUI
[ON / OFF]
[Transparent / Prof PCM / Prof Non-PCM / Cons PCM /
Cons Non-PCM]
Controls the channel status for the AES output. It provides a set of
useful channel status information (e.g. to prevent non audio signals
to be fed to speakers).
41
to de-activate the AES I/O relay
Advertisement
Table of Contents
