Table of Contents
Advertisement
D*AP4 VAP
Setup GUI – SYSTEM – System Status
The system status is a special link you can reach independently from where you are:
The System Status page provides a top level view of the various status information available for the device.
Device Status
Power 1
Power 2
Temperature
Sync Lock
Processing Status
Bypass
Interface Status
AES I/O
Interface 2 Analog Mic Turns red if a problem with the optional mic interface board has been
System Messages
System Log
Provides the hardware status of the D*AP4 VAP.
Status of the first power supply (left hand side of rear).
Status of second power supply (to the right of the first power supply)
Measured on the surface of the main PCB.
Turns red if the external sync source is lost or unstable.
Turns red if Bypass is activated.
Turns red if an AES input that is internally in use (i.e. you have routed it to
an input of a function block) has detected an error (e.g. no carrier).
detected.
[current / history]
Displays a list of messages produced by the system controller.
The system controller messages will be logged. This log information may
be downloaded from the device and sent to Junger Audio. In case of a
problem you can press: <save diagnostics file> from here or from:
SYSTEM > Admin > Diagnostics.
15
Advertisement
Table of Contents
