Fisher DPR900 User Manual page 53

4-3
Change tuning parameters according to the following procedure:
Step Button Display Action
1
w
0
PROG
Select program mode; PROG button LED starts flashing.
PROG
or
If an error code is present (e.g. E107), it appears in the digital
El07
display. Call up any additional error codes by pressing either
green increase or decrease buttons.
@@
Leave the error code mode without clearing the error by
pressing,
D
0
PROG
or
Press
TUNE
button to erase the error codes.
2
Q
0
FC 1
TUNE
*
4
v
0 50.50
TUNE
f!P
6 u
0
FC n
R
Authorization check is configured. The configured values
may only be viewed, not changed (Steps 2 and 3). Steps 4
and 5 change values only when authorization check is not
configured.
Step forward (using the green increase button) or backward
(using the green decrease button) to the desired function
code. The
SET
button flashes.
Push the
SET
button to view the current parameter value for
the selected function code.
Using the green increase and decrease buttons, set the new
value in the digital display. The
STORE
button starts to flash,
indicating that the changed value must be stored to take
effect.
Press the
STORE
button to store the new value; the PROG
button starts to flash, and the digital display shows the next
function code.
Call other function codes by using the green increase/decrease buttons, then complete Steps 3 thru
6 to change the parameters.
v
0 27.3
7
Press the flashing
PROG
button; the controller leaves the
PROG
programming mode, and the display shows the configured
display value.
May 7997