Control Panel Messages - Xerox DP N24 System Administrator Manual

Control Panel
Messages
Table 6.2 Control Panel messages and corrective actions
Message
†
0 0 0 1 -ESS
† Appears in the upper left corner
of the display.
†
0 0 0 3 -ESS
† Appears in the upper left corner
of the display.
†
0 0 0 4 -BASE RAM
† Appears in the upper left corner
of the display.
†
0 0 0 5 -BASE ROM
† Appears in the upper left corner
of the display.
Listed in Table 6.2 are Control Panel messages that either:
• Cause the printer to stop printing.
• Require the user to call for service.
Also included in Table 6.2 are common, non-error messages you
are likely to see. The messages are listed in alphabetical order.
If you have a finisher, the finisher control messages are all on the
finisher documentation on your product CD.
Description/Corrective Action
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.
A fault condition has occurred.
ACTION: Power OFF and power ON the printer. If this code appears again at
power ON, contact your dealer or Olivetti.

Control Panel Messages

Table 6.2 Page 1 of 19
Chapter 6: Troubleshooting 6-5