Xerox DP N24 System Administrator Manual page 186

Control Panel Messages
Table 6.2 Control Panel messages and corrective actions (continued)
Message
D e l e t i n g . . .
Demo Mode
D i s k F a i l u r e
D i s k F u l l
Duplex Unit Fail
P o w e r O f f / O n
E n t e r P a s s w o r d
_ x x x
E n v . F e e d e r E m p t y
E n v . F e e d e r F a i l
P o w e r O f f / O n
Fan Failure
Power OFF NOW!
6-12 DP N24, N32 and N40 System Administrator Guide
Description/Corrective Action
The secure or proof job(s) you asked to delete is(are) being deleted.
ACTION: None.
This Reset Menu selection allows you to enter the printer demonstration mode.
ACTION: Press Value Up
Select Yes and press Enter
A general failure (such as read/write) of the hard disk has occurred.
ACTION: Power OFF and power ON the printer. If this message appears again at
power ON, contact your dealer or Olivetti.
A secure or proof job spooled to the disk exceeds the available free space on the hard
disk. The job will be canceled and deleted after part of the first copy is printed.
ACTION: The job is cancelled and deleted after printing the first copy of the partial
job. Delete fonts, macros, or secure and proof jobs to make space.
The Duplex Module has failed. Printing from the Duplex Module cannot continue.
ACTION: Power OFF the Printer. Remove and reinstall the Duplex Module
following the instruction in Appendix C: Installing and Removing
Printer Options. Then Power ON the printer. If it still fails, contact your
dealer or Olivetti.
This message appears when using the Password Menu. From this menu, the Job
Menu can be accessed in order to release jobs for printing.
ACTION: Enter a valid 4 digit password using the Control Panel keys.
The Envelope Feeder is no longer being used to print because it is empty.
ACTION: Refill the Envelope feeder if it is to be used again.
The Envelope Feeder has failed. Printing from the 100 Envelope Feeder cannot
continue.
ACTION: Power OFF the Printer. Remove and reinstall the 100 Envelope Feeder
following the instruction in Appendix C: Installing and Removing
Printer Options. Power ON the printer. If it still fails, contact your dealer
or Olivetti.
The fan is not working.
ACTION: Power OFF the printer immediately and contact your dealer or Olivetti.
or Value Down to toggle between
to enter the demonstration mode.
Table 6.2 Page 8 of 19
Yes and No.