Replacing The Toner Cartridge; Standard Configuration; Duplex Configuration - Xerox DP N24 System Administrator Manual

Replacing the Toner Cartridge

Replacing the
Toner Cartridge
B-2 DP N24, N32 and N40 System Administrator Guide
This section describes how to replace the DP N40 Toner Cartridge
in both a standard configuration printer and a printer with a Duplex
Module attached.
• Do not expose the Toner Cartridge to direct sunlight or artificial
light for more than 15 minutes. Overexposure will permanently
damage the photosensitive imaging drum.
• Do not open the drum shutter or touch the green imaging drum
surface.
• Be sure to shake the Toner Cartridge as directed to distribute
the toner inside the cartridge. Print quality may be degraded if
the toner is not evenly distributed. If the toner has not been
properly freed by shaking the cartridge, you may hear a noise
when powering on the printer, and the Toner Cartridge may be
damaged.
• Never touch the Fuser area inside the printer (where a label
indicates high temperature).
If your printer does not have a Duplex Module installed, go to the
section "Standard Configuration" (page B-3).
If your printer has the Duplex Module installed, go to the section
"Duplex Configuration" (page B-7).