Cisco ASA 5505 Configuration Manual page 1151

Chapter 54 Configuring the IPS Application on the AIP SSM and SSC
If you use virtual sensors on the AIP SSM only, you can specify a sensor name using this option. If you
use multiple context mode on the adaptive security appliance, you can only specify sensors that you
assigned to the context (see the
section on page
multiple context mode, you can specify a default sensor for the context. In single mode or if you do not
specify a default sensor in multiple mode, the traffic uses the default sensor that is set on the AIP SSM.
Click OK.
Step 9
Feature History for the AIP SSM/SSC
Table 54-1
backwards-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 54-1 Feature History for the AIP SSM/SSC
Feature Name
AIP SSM
Virtual sensors
AIP SSC for the ASA 5505
OL-20339-01
"Assigning Virtual Sensors to a Security Context (AIP SSM Only)"
54-7). If you do not specify a sensor name, then the traffic uses the default sensor. In
lists each feature change and the platform release in which it was implemented. ASDM is
Platform
Releases
7.0(1)
8.0(2)
8.2(1)
Feature Information
The AIP SSM was introduced.
The following screen was introduced: Configuration >
Firewall > Service Policy Rules > Add/Edit Service Policy
Rule > Intrusion Prevention.
Virtual sensor support was introduced. Virtual sensors let
you configure multiple security policies on the AIP SSM.
The following screen was modified: Context Management >
Security Contexts > Edit Context.
The AIP SSC was introduced.
The following screen was introduced: Configuration >
Device Setup > SSC Setup.
Cisco ASA 5500 Series Configuration Guide using ASDM
Feature History for the AIP SSM/SSC
54-9