Cisco ASA 5505 Configuration Manual page 1132

Asa 5500 series
Hide thumbs Also See for ASA 5505:
Table of Contents

Advertisement

Default Settings
Default Settings
Table 53-1
Table 53-1
Parameters
Management VLAN (SSC only)
Management IP address
Management hosts (SSC only)
Gateway
The default management IP address on the adaptive security appliance is 192.168.1.1/24.
Note
Configuring the SSC Management Interface
An SSC does not have any external interfaces. You can configure a VLAN as a management VLAN to
allow access to an internal management IP address over the backplane. By default, VLAN 1 is enabled
for the SSC management address. You can only assign one VLAN as the SSC management VLAN. This
section describes how to change the management VLAN. It also describes how to change the default
management IP address, allowed hosts, and gateway. See the
more information about defaults.
Prerequisites
For the VLAN you want to use for the SSC management interface, configure the switch port and VLAN
interface on the ASA 5505 according to the procedures listed in
Configuration (ASA 5505)."
to the network.
Restrictions
Do not configure NAT for the management address if you intend to access it using ASDM. For initial
setup with ASDM, you need to access the real address. After initial setup (where you set the password
in the SSC), you can configure NAT and supply ASDM with the translated address when you want to
access the SSC.
Detailed Steps
If you are configuring the SSC for the first time, in the ASDM main window, choose Configuration >
Step 1
Device Setup > SSC Setup.
Note
Cisco ASA 5500 Series Configuration Guide using ASDM
53-4
lists the default network settings for SSMs and SSCs.
Default Network Parameters
This configuration is required so the SSC interface is physically connected
If you click the IPS tab before you have configured the SSC, the Stop dialog box appears. Click
OK to have ASDM redirect you to the SSC Setup pane. You must define the settings in the SSC
Setup pane before you can access any part of the GUI.
Chapter 53
Default
VLAN 1
192.168.1.2/24
192.168.1.0/24
192.168.1.1
"Default Settings" section on page 53-4
Chapter 8, "Starting Interface
Managing SSMs and SSCs
for
OL-20339-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asa 5510Asa 5540Asa 5520Asa 5550Asa 5580

Table of Contents