Cisco ASA 5505 Configuration Manual page 1371

Chapter 64 General VPN Setup
•
•
•
•
•
Modes
The following table shows the modes in which this feature is available:
Firewall Mode
Routed
•
Add or Edit MUS Access Control
The Add or Edit MUS Access Control dialog box lets you configure MUS access.
Fields
•
•
•
Configuring Clientless SSL VPN Connections
Use the Clientless SSL VPN Access Connections dialog box to configure clientless SSL VPN access
parameters. This dialog box also records the configuration choices you make in its child dialog boxes.
Fields
•
•
•
OL-20339-01
Service Port—If you choose to enable the service, specify which port number for the service to use.
The port must be between 1 and 65535 and must match the corresponding value provisioned into the
WSA with the management system. The default is 11999.
Change Password—Enables you to change the WSA access password.
WSA Access Password—Specify the shared secret password required for authentication between
the ASA and WSA. This password must match the corresponding password provisioned into the
WSA with the management system.
Confirm Password—Re-enter the specified password.
Show WSA Sessions—Allows you to view session information of WSAs connected to the ASA.The
host IP address of the WSA that is connected (or has been connected) and the duration of the
connection is returned in a dialog box.
Security Context
Transparent Single
—
•
Interface Name—Use the drop-down menu to choose which interface name you are adding or
editing.
IP Address—Enter either an IPv4 or IPv6 address.
Mask—Use the drop-down menu to choose the appropriate mask.
Access Interfaces—Lets you select from a table the interfaces on which to enable access. The fields
in this table include the interface name and check boxes enabling you whether to allow access and
require a certificate for authentication.
Access Port—Specifies the access port for the connection. The default value is 443.
Connections—Provides a connection table that shows the records that determine the connection
policy for this connection (tunnel group). Each record identifies a default group policy for the
connection and contains protocol-specific connection parameters.
Add—Opens the Add Clientless SSL VPN dialog box for the selected connection.
–
Configuring Clientless SSL VPN Connections
Multiple
Context System
— —
Cisco ASA 5500 Series Configuration Guide using ASDM
64-61