Table of Contents
Advertisement
2
Vertically on the sides of the module
3
Vertically in the corner channels in the rear of the module (shielded
cables only)
CAUTION — Service Interruption
Damage to Equipment
Cables must be routed as perpendicular as possible
to any nearby power cables. Avoid routing cables
near power cables if alternate routing is available. (At
the rear of the module, cables routed between the I/O
panel and the rear cover can be parallel to the power
cables because the panel provides EMI shielding.)
Avaya recommends that you use the 90° connector end of the cable to route
the cable through a module or cabinet instead of the 180° end, since some
openings are small (see Figures 15 and 16). Furthermore, Avaya recommends
that you route cables top-to-bottom so gravity will ease installation.
Figure 15
90° cable connector
Preparing for installation
Large System Installation and Commissioning
Page 61 of 436
553-7497
Advertisement
Table of Contents
