Table of Contents
Advertisement
Figure 116
Module mounting bolts
Note: There is an EMI shield (it looks like a brass grill) on the top of each
pedestal. Leave this shield on the pedestal. Use a few pieces of tape to
hold the shield in position, so the holes for the mounting bolts are aligned
with the screw holes on the pedestal. After the module is secured, remove
as much of the tape as possible.
4
Position and secure modules:
a.
Locate the positioning guides on the pedestal. Make sure the module
being added is facing the same direction as the column.
b.
Place the module being added on the pedestal and adjust it until it is
seated securely on the positioning guides.
c.
Secure the mounting bolts for the module.
d.
Place the module that was removed onto the top of the module that
was added and secure it with the mounting bolts.
Adding a module to a column
Mounting
bolts
Large System Installation and Commissioning
Page 351 of 436
553-3057
Advertisement
Table of Contents
