Table of Contents
Advertisement
Page 290 of 436
Preparing to power up – DC
Turning DC power ON
NN43021-310
Standard 06.01
Powering up the system and initial loading
CAUTION
Verify that the safety grounds are properly connected.
Procedure 46
Preparing to power up – DC
1
Set the AC service panel circuit breakers to each rectifier OFF.
2
Remove the DC power distribution fuses or set the distribution circuit
breakers OFF.
3
Set all circuit breakers in the rear of each pedestal OFF.
4
Set the power supply switches in each module OFF.
5
Set the ringing generators in each IPE or PE module OFF.
6
Set the blower unit in each pedestal OFF.
7
Set all faceplate switches to ENB.
8
Proceed to "Turning DC power ON" on
Follow Procedure 47 to turn the DC power on.
March 2013
page
End of Procedure
290.
Advertisement
Table of Contents
