Table of Contents
Advertisement
Optioning the System Utility Card
Cabling Common Equipment in a Multi Group system
To install the system utility card, first identify Core/Net 0 and Core/Net 1
shelves. Then adjust the DIP switches according to Table 27 below.
Table 27
System Utility Card DIP switch settings
DIP switch 1
DIP switch 2
Figure 89 on
page 220
cards are not installed, refer to this figure to add or replace cards.
Core/Net 0
on
on
shows Core card (front side) placement. If the Core
Large System Installation and Commissioning
Page 219 of 436
Core/Net 1
off
on
Advertisement
Table of Contents
