Connecting a switch box and terminal to
SDI and COM1 ports
Connecting a system terminal or modem
Use Procedure 20 to connect COM1 ports to a switch box and a terminal (see
Figure 71 on
page 180
Procedure 20
Connecting a switch box and terminal to the SDI and COM1 ports
1
Set the terminal to 9600 baud, 7 data, space parity, one stop bit, full
duplex, XON.
2
Connect an NT8D95 cable to the terminal and to the switch box.
3
Connect NT8D95 cables to a matching connector on the switch box.
When using an A0377992 ABCDE box, connect:
— CPU 0 to connector A.
— CPU 1 to connector B.
— The SDI port to connector D (connector C is common).
4
Connect NT8D95 cables from the switch box to J25 on the I/O panel in
the rear of each cPCI Core/Network Module.
5
Connect an NT8D95 cable from the switch box to the I/O panel slot for the
SDI card.
6
To communicate with the system in general, set the switch box to the SDI
port. To communicate directly with a COM1 port, switch the cable as
needed.
and Figure 72 on
page
End of Procedure
Large System Installation and Commissioning
Page 181 of 436
182).