Table of Contents
Advertisement
7
Install the perforated panel and top cap on the module being added:
a.
Position the perforated panel and slide it slightly to the right (at the
rear). Install the screw that secures the panel and LED bracket.
b.
Position wiring from the perforated panel so it rests in the cable well
located next to the orange power connector at the rear of the module
(see Figure 127 on
Figure 127
Cable well location
Top of
module
c.
Position the top cap and install the bolts that secure it.
d.
Replace the air exhaust grills at the front and rear of the top cap.
8
Reconnect power to the top cap:
a.
Connect the system monitor cable to J2 on the backplane. Line up
the alignment tab on the connector and snap on the pin headers to
position the connector correctly (see Figure 128 on
Figure 128
Monitor cable J2 backplane alignment tab and key alignment
Alignment tab
Side view of connectors
Adding a module to a column
page
365).
Cable well
Orange connector
View at rear of module
on backplane
connector
Large System Installation and Commissioning
Page 365 of 436
Bracket
553-5889
page
365).
Key on cable
connector
553-5885
Advertisement
Table of Contents
