Cabling The Core Side - Avaya 1000M Installation And Commissioning Manual

Cabling the Core side

Table 20
Field-installed Core cables (internal)
Order Code
NT4N88AA
NT4N88BA
NT4N90BA
NTRC17BA
customer supplied
Note: If there is no connection to a LAN, connect the two LAN 1 connectors using the
NTRC17BA crossover cable.
Table 21
Factory installed Core cables (internal)
Order Code
NT4N4405
NT4N29AA
NT4N89AA
Cabling Common Equipment in a Single Group system
2 NT4N48 System Utility card. The System Utility card is located in slot
c15.
3 NT4N39AA Call Processor PIV (CP PIV). This card is located in the
slot marked CP.
This section describes installation of the Core cables. Table 20 lists
field-installed cables. Table 21 lists factory-installed cables.
Description
COM1 (DTE/terminal)
COM2 (DCE/modem)
Ethernet (CP PIV card to I/O panel)
Crossover Ethernet cable (Core to Core)
Standard Ethernet cable (I/O Panel to LAN
switch)
Description
Shelf Power: Net backplane to Core backplane
cCNI to 3PE Core/Net shelf cable
System Utility Card to XSM (see Figure 80)
Large System Installation and Commissioning
Page 197 of 436
Number required
per system
2
2
2
1
2
Number required
per system
2
4
2