Supervision; Overview; Short Circuit Check; Network - Bosch Plena Software Manual

Plena Voice Alarm System | Software Manual | Supervision
5

Supervision

5. 1

Overview

Use the Supervision window to configure the
supervision settings of the system.
figure 5. 1 : Supervision window
Note
See the Plena Voice Alarm System Installation
and User Instructions (9922 141 1037x) for
more information about supervision.
The buttons at the bottom of the Supervision window
are used to:
• Save changes (Save)
• Cancel changes (Cancel)
• Close the window (Close)
• Enable supervision of all functions (Select All)
• Disable supervision of all functions (Clear All)
5.2

Short circuit check

Use the Short circuit check box to enable and disable
the short circuit check of the system. By default, this box
contains a checkmark therefore if a loudspeaker line has
a short circuit, the line is isolated.
Bosch Security Systems | 2005-10 | 9922 141 10384 en
5.3

Network

Use the Network box to enable and disable supervision
of the network. By default, this box contains a
checkmark, which means that supervision of the
network is enabled.
5.4

Power amplifiers

Use the Call/EMG checkbox to enable and disable
supervision of the call power amplifier. By default, this
box contains a checkmark, which means that
supervision of the call power amplifier is enabled.
Use the Music/Spare checkbox to enable and disable
supervision of the spare power amplifier. By default, this
box contains a checkmark, which means that
supervision of the spare power amplifier is enabled.
5.5

Ground short

Use the Ground short box to enable and disable ground
short supervision. By default ground short supervision is
enabled to detect a short to ground of the loudspeaker
lines. The system still functions.
5.6

Mains power

Use the Mains box to enable and disable mains power
supervision. By default, this box contains a checkmark,
which means that mains power supervision is enabled.
5.7

Battery

Use the Battery box to enable and disable battery
supervision. By default, this box contains a checkmark,
which means that battery supervision is enabled.
5.8

Message

Use the Message box to enable and disable message
supervision. By default, this box contains a checkmark,
which means that message supervision is enabled.
5.9

EMG mic

Use the EMG mic box to enable and disable supervision
of the hand-held emergency microphone that is
connected to he voice alarm controller and the RCs. By
default the emergency microphone is enabled.
5. 1 0

RC panel audio

Supervises the audio BUS between the RC and the
controller. By default the RC panel audio is enabled.
en | 19