Table of Contents
Advertisement
Solution 144
Quick Start Guide
Zone Type Zn1
01 - Burglary Delay 1
Press
Figure 28: List Option Programming Display
Cloc k Pro gra m m ing
Use the left and right arrow keys to move to the field then
use the up and down arrow keys to change. Press [OK] to
save or [MENU] to exit without saving.
Scroll through hours to change from am to pm.
i
Note
Set Date And Time
01-Jan-2012 12:00
i
Press
Figure 29: Clock Programming Display
G e tt in g Sta r ted B a ck To B as e
The following steps are the mimimum requirements to get
the system reporting back to base. Examples assume the
panel is disarmed with no alarms and starting from factory
default settings.
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Set date and time.
MENU 7-1-0
3. Change default installer PIN.
MENU 1-5-2
4. Change default master PIN.
MENU 1-1-1
5. Enter (Client) account number for Area 1.
MENU 2-2-0
6. Enter base station primary telephone number.
MENU 5-1-1
7. Enter base station secondary telephone number.
MENU 5-1-2
8. Press and hold down [MENU] to exit.
20
0-9 OK to SAVE
OK to SAVE
S er vice M od e
Service mode when activated disables dialler reporting,
prevents all alarms and prevents all users from arming the
system.
To Turn Service Mode ON
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Turn service mode on.
MENU 7-0-8
3. Follow display prompts.
4. Hold down [MENU] to exit.
Keypads will display the word Service when service
i
mode is active.
Note
To Turn Service Mode OFF
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Turn service mode off.
MENU 7-0-8
3. Follow display prompts.
4. Hold down [MENU] to exit.
Keypads will display the word Service when service
i
mode is active.
Note
D efaul t ing Th e Sys te m
Defaulting the system will reset all programming options
back to the factory default setting. All programming
information will be erased.
To Hardware Default
1. Remove all power to the system - AC and battery.
2. Press and hold the default push button, then apply
power to the control panel.
3. Release the default button, The panel will reset and
revert to normal operation when default is complete.
To Software Default
1. Enter programming mode.
[1][2][3][4] + [MENU]
2. Select factory default option.
MENU 7-0-4
3. The panel will reset and revert to normal operation
when the default is complete.
Bosch Security Systems 10/12 BLCC600R
Advertisement
Table of Contents
