Configuring Ip - Alcatel-Lucent ALU-Dm 744-I Manual

1 Introduction
connection 1 username oficina1
connection 1 password oficina1
;
connection 2 default
connection 2 destination-address 2222222
connection 2 username oficina2
connection 2 password oficina2
;
connection 3 default
connection 3 destination-address 3333333
connection 3 username oficina3
connection 3 password oficina3
;
pool-name RDSI
;
exit
;
;
;
network dialroute2
; -- DR interface configuration --
no ip address
;
connection 1 default
connection 1 destination-address 4444444
connection 1 username oficina4
connection 1 password oficina4
;
connection 2 default
connection 2 destination-address 5555555
connection 2 username oficina5
connection 2 password oficina5
;
pool-name RTC
;
exit
;
;
;
dump-command-errors
end
; --- end ---
Config>
Note
For further information on configuring PPP, please see manual ALU-Dm710-I PPP Interface.

1.5.6 Configuring IP

Once you have configured everything relating to the interfaces, you need to configure the IP protocol.
1.5.6.1 Configuring IP addresses
Configure the Ethernet IP address and the internal IP address is set to coincide with the said address.
Config>network ethernet0/0
-- Ethernet Interface User Configuration --
ethernet0/0 config>ip address 7.7.7.7 255.255.255.0
ethernet0/0 config>exit
Config>protocol ip
-- Internet protocol user configuration --
IP config>internal-ip-address 7.7.7.7
IP config>list addresses
24
Alcatel-Lucent Enterprise
Dial Routing