Dodge dakota 2002 Service Manual page 2244

DR
OVERDRIVE UNIT (Continued)
(8) Remove direct clutch drum outer retaining ring
(Fig. 149).
(9) Mark annulus gear and output shaft for assem-
bly alignment reference (Fig. 150). Use punch or
scriber to mark gear and shaft.
Fig. 149 Clutch Drum Outer Retaining Ring Removal
1 - OUTER RETAINING RING
Fig. 150 Marking Annulus Gear And Output Shaft
For Assembly Alignment
1 - OUTPUT SHAFT
2 - HAMMER
3 - PUNCH
(10) Remove snap-ring that secures annulus gear
on output shaft (Fig. 151). Use two screwdrivers to
unseat and work snap-ring out of groove as shown.
(11) Remove annulus gear from output shaft (Fig.
152). Use rawhide or plastic mallet to tap gear off
shaft.
GEAR CASE AND PARK LOCK
(1) Remove locating ring from gear case.
AUTOMATIC TRANSMISSION - 48RE
Fig. 151 Annulus Gear Snap-Ring Removal
1 - OUTPUT SHAFT
2 - ANNULUS GEAR
3 - SNAP-RING
Fig. 152 Annulus Gear Removal
1 - OUTPUT SHAFT
2 - ANNULUS GEAR
(2) Remove park pawl shaft retaining bolt and
remove shaft, pawl and spring.
(3) Remove reaction plug snap-ring and remove
reaction plug.
(4) Remove output shaft seal.
CLEANING
Clean the geartrain and case components with sol-
vent. Dry all parts except the bearings with com-
pressed air. Allow bearings to air dry.
Do not use shop towels for wiping parts dry unless
the towels are made from a lint-free material. A suffi-
cient quantity of lint (from shop towels, cloths, rags,
etc.) could plug the transmission filter and fluid pas-
sages.
Discard the old case gasket and seals. Do not
attempt to salvage these parts. They are not reus-
21 - 405