Dodge dakota 2002 Service Manual page 2344

DR
AUTOMATIC TRANSMISSION - 45RFE/545RFE (Continued)
(20) Install the number 12 bearing over the output
shaft and against the rear planetary gear set. The
flat side of the bearing goes toward the planetary
gearset and the raised tabs on the inner race should
face the rear of the transmission.
(21) Install the reverse/input planetary assembly
through the low/reverse clutch assembly (Fig. 37).
Fig. 37 Install Input/Reverse Planetary Assembly
1 - INPUT/REVERSE PLANETARY ASSEMBLY
2 - BEARING NUMBER 9
3 - BEARING NUMBER 12
(22) Install the park sprag onto the output shaft
(Fig. 38).
(23) Install the snap-ring to hold the park sprag
onto the output shaft (Fig. 39).
Fig. 38 Install Park Sprag Gear
1 - PARK SPRAG GEAR
AUTOMATIC TRANSMISSION - 45RFE/545RFE
Fig. 39 Install Park Sprag Snap-Ring
1 - SNAP-RING
(24) Install the 2C reaction plate into the trans-
mission case (Fig. 40). The reaction plate is direc-
tional. The plate must be installed with the flat side
toward the front of the transmission.
(25) Install the 2C clutch pack into the transmis-
sion case (Fig. 40).
Fig. 40 Install 2C Clutch Pack
1 - SNAP-RING
2 - PLATE
3 - DISC
4 - REACTION PLATE
(26) Install the number 8 bearing inside the reac-
tion carrier with the outer race against the reaction
planetary carrier.
21 - 505