Dodge dakota 2002 Service Manual page 2348

DR
AUTOMATIC TRANSMISSION - 45RFE/545RFE (Continued)
(49) Using Installer 8255, install the inner trans-
mission front cover snap-ring the remainder of the
way onto the oil pump (Fig. 49).
Fig. 49 Seat Snap-Ring Using Tool 8255
1 - TOOL 8255
2 - SNAP-RING
(50) Install the valve body (Fig. 50). Verify that
the pin on the manual lever has properly engaged
the TRS selector plate. Tighten the valve body to
transmission case bolts to 12 N·m (105 in.lbs.).
Fig. 50 Install Valve Body Assembly
1 - VALVE BODY TO CASE BOLT (6)
(51) Install a new primary oil filter seal in the oil
pump inlet bore. Seat the seal in the bore with the
butt end of a hammer, or other suitable tool.
CAUTION: The primary oil filter seal MUST be fully
installed flush against the oil pump body. DO NOT
AUTOMATIC TRANSMISSION - 45RFE/545RFE
install the seal onto the filter neck and attempt to
install the filter and seal as an assembly. Damage to
the transmission will result.
(52) Install the primary oil filter and the oil cooler
return filter (Fig. 51). Tighten the screw to hold the pri-
mary oil filter to the valve body to 4.5 N·m (40 in.lbs.).
Using Oil Filter Wrench 8321, tighten the cooler return
oil filter to the transmission case to 14 N·m (125 in.lbs.).
Fig. 51 Install Primary Oil and Cooler Filters
1 - PRIMARY OIL FILTER
2 - COOLER RETURN FILTER
3 - COOLER RETURN FILTER BYPASS VALVE
4 - VALVE BODY
(53) Apply RTV silicone to the oil pan and install
the transmission oil pan. Tighten the bolts to 12 N·m
(105 in.lbs.).
(54) Install the input, output, and line pressure sen-
sors (Fig. 52). Tighten the bolts to 12 N·m (105 in.lbs.).
Fig. 52 Install Input, Output, and Line
1 - OUTPUT SPEED SENSOR
2 - LINE PRESSURE SENSOR
3 - INPUT SPEED SENSOR
Pressure Sensors
21 - 509