Dodge dakota 2002 Service Manual page 2218

DR
ELECTRONIC GOVERNOR (Continued)
(4) Remove screws
retainer to governor body.
(5) Separate solenoid retainer from governor (Fig.
81).
Fig. 81 Pressure Solenoid Retainer
1 - PRESSURE SOLENOID RETAINER
2 - GOVERNOR
(6) Pull solenoid from governor body (Fig. 82).
(7) Pull pressure sensor from governor body.
(8) Remove bolts holding governor body to valve
body.
Fig. 82 Pressure Solenoid and O-ring
1 - PRESSURE SOLENOID
2 - O-RING
3 - GOVERNOR
holding pressure solenoid
AUTOMATIC TRANSMISSION - 48RE
(9) Separate governor body from valve body (Fig.
83).
(10) Remove governor body gasket.
Fig. 83 Governor Body and Gasket
1 - GOVERNOR BODY
2 - GASKET
INSTALLATION
Before installing the pressure sensor and solenoid
in the governor body, replace o-ring seals, clean the
gasket surfaces and replace gasket.
(1) Place gasket in position on back of governor
body (Fig. 84).
(2) Place governor body in position on valve body.
(3) Install bolts to hold governor body to valve
body.
Fig. 84 Governor Body and Gasket
1 - GOVERNOR BODY
2 - GASKET
21 - 379