Dodge dakota 2002 Service Manual page 1768

DR
FUEL LINES (Continued)
1 - FUEL INJECTOR
2 - HIGH-PRESSURE LINE
3 - INJECTOR MOUNTING BOLTS
4 - FUEL INJECTOR RAIL
INSTALLATION
All high-pressure fuel lines are of the same length
and inside diameter. Correct high-pressure fuel line
usage and installation is critical to smooth engine
operation.
(1) Position fuel line support clamp to fuel line.
Install clamp nuts/bolts and tighten finger tight.
(2) Position proper fuel line to proper injector on
engine. Tighten fittings hand tight at both ends of
line.
(3) Tighten fuel lines at high pressure injector con-
nector to 30 N·m (22 lb. ft.).
(4) Tighten fuel lines at fuel rail to 30 N·m (22 lb.
ft.).
(5) Tighten clamp/support nuts and bolts.
(6) Install engine lifting bracket and bolt. Tighten
bolt to 77 N·m (56 lb.ft.).
Fig. 18 HIGH PRESSURE FUEL LINES
5 - SEPARATE FITTING (TYPICAL)
6 - CONNECTOR TUBE RETAINER (FITTING)
7 - CONNECTOR TUBE
replaced, install intake manifold air heater elements
to top of intake manifold. Refer to Intake Air Heater
Removal / Installation for procedures.
metal bracket upward and tighten 2 bolts at rear of
cylinder head.
bracket bolts at intake manifold.
batteries.
Priming.
FUEL DELIVERY - DIESEL
(7) If fuel line at either #1 or #2 cylinder has been
(8) If fuel line at #6 cylinder has been replaced, tilt
(9) Install remaining fuel line support clamps and
(10) Connect both negative battery cables to both
(11) Prime fuel system. Refer to Fuel System
(12) Check lines/fittings for leaks.
14 - 71