Dodge dakota 2002 Service Manual page 2129

21 - 290 AUTOMATIC TRANSMISSION - 46RE
VALVE BODY (Continued)
(17) Remove screws attaching pressure adjusting
screw bracket to valve body and transfer plate (Fig.
304). Hold bracket firmly against spring tension
while removing last screw.
Fig. 304 Adjusting Screw Bracket Fastener
1 - T25 TORX™ BIT
2 - REMOVE THESE SCREWS FIRST
3 - BRACKET
4 - BRACKET
5 - REMOVE THIS SCREW LAST
(18) Remove adjusting screw bracket, line pressure
adjusting screw, pressure regulator valve spring and
switch valve spring (Fig. 305). Do not remove throttle
pressure adjusting screw from bracket and do not
disturb setting of either adjusting screw during
removal.
(19) Turn upper housing over and remove switch
valve, regulator valve and spring, and manual valve
(Fig. 306).
(20) Remove kickdown detent, kickdown valve, and
throttle valve and spring (Fig. 306).
(21) Loosen left-side 3-4 accumulator housing
attaching screw about 2-3 threads. Then remove cen-
ter and right-side housing attaching screws (Fig.
307).
Fig. 305 Adjusting Screw Bracket
1 - SWITCH VALVE SPRING
2 - LINE PRESSURE SCREW
3 - THROTTLE PRESSURE ADJUSTING SCREW
4 - ADJUSTING SCREW BRACKET
5 - PRESSURE REGULATOR VALVE SPRING
DR