Dodge dakota 2002 Service Manual page 2478

DR
TRANSFER CASE - NV271 (Continued)
Fig. 51 Output Shaft Rear Bearing Installation Depth
1 - BEARING (SEATED) AT LOWER EDGE OF CHAMFER
2 - CHAMFER
(13) Remove seal from oil pump with suitable pry
tool.
(14) Install new seal in oil pump with Installer
7888 (Fig. 52).
Fig. 52 Oil Pump Seal Installation
1 - HOUSING SEAL
2 - SPECIAL TOOL 7888
3 - OIL PUMP FEED HOUSING
(15) Remove the rear output shaft bearing snap-
ring (Fig. 53) from the rear case half.
(16) Remove the rear output shaft bearing from
the rear case using Installer 7888 (Fig. 54).
TRANSFER CASE - NV271
Fig. 53 Remove Rear Output Bearing Outer
Snap-Ring
1 - REAR CASE HALF
2 - REAR OUTPUT SHAFT BEARING
3 - SNAP-RING
Fig. 54 Remove Rear Output Shaft Bearing
1 - REAR CASE HALF
2 - INSTALLER 7888
21 - 639