Dodge dakota 2002 Service Manual page 2065

21 - 226 AUTOMATIC TRANSMISSION - 46RE
OVERDRIVE UNIT (Continued)
(4) Remove thrust
clutch hub.
(5) Remove overrunning clutch from hub.
(6) Mark position of annulus gear and direct clutch
drum for assembly alignment reference (Fig. 160).
Use small center punch or scriber to make alignment
marks.
Fig. 160 Marking Direct Clutch Drum And Annulus
Gear For Assembly Alignment
1 - DIRECT CLUTCH DRUM
2 - HAMMER
3 - PUNCH
(7) Remove direct clutch drum rear retaining ring
(Fig. 161).
(8) Remove direct clutch drum outer retaining ring
(Fig. 162).
(9) Mark annulus gear and output shaft for assem-
bly alignment reference (Fig. 163). Use punch or
scriber to mark gear and shaft.
Fig. 161 Clutch Drum Inner Retaining Ring Removal
1 - INNER RETAINING RING
2 - DIRECT CLUTCH DRUM
3 - ANNULUS GEAR
bearing from overrunning
Fig. 162 Clutch Drum Outer Retaining Ring Removal
1 - OUTER RETAINING RING
Fig. 163 Marking Annulus Gear And Output Shaft
For Assembly Alignment
1 - OUTPUT SHAFT
2 - HAMMER
3 - PUNCH
DR