Dodge dakota 2002 Service Manual page 1897

21 - 58 MANUAL TRANSMISSION - NV4500
MANUAL TRANSMISSION - NV4500 (Continued)
(16) Remove first gear clutch cone (Fig. 57).
(17) Remove first gear clutch gear rear snap ring
from mainshaft hub (Fig. 57).
NOTE: Do not remove this snap ring unless main-
shaft is being replaced.
(18) Remove mainshaft rear bearing, with Puller
Flange 6444-1 and Puller Rods 6444-3 for 4X2 or
6444-4 for 4X4.
(19) Position the first Jaw 6445 on the bearing
cone and seat Puller Flange 6444-1 in notch of jaw
(Fig. 58).
(20) Install second Jaw 6445 on the bearing cone
and puller flange. Slide Collar 6444-8 over jaws to
hold them in place.
1 - REAR BEARING
2 - FLANGE
3 - JAW
4 - COLLAR
Fig. 58 MAINSHAFT REAR BEARING PULLER
Fig. 57 FIRST GEAR CLUTCH GEAR
1 - CLUTCH GEAR SNAP RING (REAR)
2 - FIRST SPEED CLUTCH GEAR
5 - MAINSHAFT
6 - PULLER
7 - RODS
8 - JAW
DR