Dodge dakota 2002 Service Manual page 2311

21 - 472 AUTOMATIC TRANSMISSION - 48RE
VALVE BODY (Continued)
VALVE BODY UPPER HOUSING
(1) Note location of check balls in valve body upper
housing (Fig. 301). Then remove the one large diam-
eter and the five smaller diameter check balls.
(2) Remove governor plug and shuttle valve covers
(Fig. 303).
(3) Remove E-clip that secures shuttle valve sec-
ondary spring on valve stem (Fig. 302).
(4) Remove throttle plug, primary spring, shuttle
valve, secondary spring, and spring guides (Fig. 303).
(5) Remove boost valve retainer, spring and valve
if not previously removed.
(6) Remove throttle plug and 1-2 and 2-3 governor
plugs (Fig. 290).
(7) Turn upper housing around and remove limit
valve and shift valve covers (Fig. 304).
(8) Remove limit valve housing. Then remove
retainer, spring, limit valve, and 2-3 throttle plug
from limit valve housing (Fig. 304).
(9) Remove 1-2 shift control valve and spring (Fig.
304).
(10) Remove 1-2 shift valve and spring (Fig. 304).
(11) Remove 2-3 shift valve and spring from valve
body (Fig. 304).
(12) Remove pressure plug cover (Fig. 304).
(13) Remove line pressure sleeve, throttle pressure
plug and spring (Fig. 304).
Fig. 301 Check Ball Locations In Upper Housing
1 - SMALL DIAMETER CHECK BALLS (5)
2 - LARGE DIAMETER CHECK BALL (1)
Fig. 302 Shuttle Valve E-Clip And Secondary Spring
1 - E-CLIP
2 - SECONDARY SPRING AND GUIDES
3 - SHUTTLE VALVE
DR