Dodge dakota 2002 Service Manual page 1612

DR
ENGINE 8.0L (Continued)
(21) Install the generator and wire connections
(Refer to 8 - ELECTRICAL/CHARGING/GENERA-
TOR - INSTALLATION).
(22) Install the upper crossmember.
(23) Install radiator (Refer to 7 - COOLING/EN-
GINE/RADIATOR - INSTALLATION).
(24) Connect the lower radiator hose.
(25) Install the transmission oil cooler (Refer to 7 -
COOLING/TRANSMISSION/TRANS
INSTALLATION).
(26) Connect the transmission cooler lines.
(27) Connect the power steering hoses, if equipped.
(28) Install the fan shroud.
(29) Install the fan (Refer to 7 - COOLING/EN-
GINE/RADIATOR FAN - INSTALLATION).
(30) Connect the top radiator hose.
(31) Install the washer fluid reservoir bottle (Refer
to 8 - ELECTRICAL/WIPERS/WASHERS - INSTAL-
LATION).
(32) If equipped, install the condenser (Refer to 24
- HEATING & AIR CONDITIONING/PLUMBING/
A/C CONDENSER - INSTALLATION).
(33) Install the A/C compressor with the lines
attached (Refer to 24 - HEATING & AIR CONDI-
TIONING/PLUMBING/A/C
INSTALLATION).
(34) Install the serpentine belt (Refer to 7 - COOL-
ING/ACCESSORY DRIVE/DRIVE BELTS - INSTAL-
LATION).
(35) Evacuate (Refer to 24 - HEATING & AIR
CONDITIONING/PLUMBING - STANDARD PRO-
CEDURE) and charge the air conditioning system, if
equipped (Refer to 24 - HEATING & AIR CONDI-
TIONING/PLUMBING - STANDARD PROCEDURE).
(36) Add coolant to the cooling system (Refer to 7 -
COOLING - STANDARD PROCEDURE).
(37) Install the battery.
(38) Warm engine and adjust as required.
(39) Road test vehicle.
COOLER -
COMPRESSOR -
SPECIFICATIONS
TORQUE
TORQUE CHART 8.0L ENGINE
DESCRIPTION
Camshaft Sprocket—Bolt
Camshaft Thrust Plate—
Bolts
Coil Pack Bracket—Bolts
Connecting Rod Cap—Bolts
Main Bearing—Bolts
Crankshaft Pulley/Damper—
Bolt
Crankshaft Rear Seal
Retainer—
Bolts
Cylinder Head—Bolts
Cylinder Head Cover—Bolts
Drive Plate to Crankshaft—
Bolts
Drive Plate to Torque
Converter—
Bolts
EGR Tube—Nut
EGR Valve—Bolts
Engine Support Bracket/
Insulator—
Through Bolt
Engine Support Bracket/
Insulator to
Block—Bolts
Exhaust Manifold to Cylinder
Head—
Bolt
Generator Mounting—Bolt
Generator to Intake Manifold
Bracket
—Bolts
ENGINE 8.0L
N·m Ft.
Lbs.
75 55
22 16
21 —
61 45
Step 1 27 20
Step 2 115 85
312 230
22 16
Step 1 58 43
Step 2 143 105
16 —
75 55
47 35
34 25
20 —
68 50
47 35
22 16
41 30
41 30
9 - 363
In.
Lbs.
—
—
190
—
—
—
—
—
—
—
144
—
—
—
174
—
—
—
—
—