Dodge dakota 2002 Service Manual page 1576

DR
CRANKSHAFT REAR OIL SEAL RETAINER (Continued)
Fig. 77 Installing Seal Using Alignment Tool and
1 - SEAL PILOT TOOL
2 - INSTALLATION TOOL
3 - SEAL
4 - RETAINER
Fig. 78 Trimming Excess Gasket Material
1 - GASKET
(11) Install the flywheel housing and bolts. Torque
bolts to 77 N·m (57 ft. lbs.).
(12) Install the flywheel or converter drive plate.
Tighten bolts to 137 N·m (101 ft. lbs.).
(13) Install the starter motor and torque to 43 N·m
(21 ft. lbs.)(Refer to 8 - ELECTRICAL/STARTING/
STARTER MOTOR - INSTALLATION).
(14) Install the transmission and transfer case (if
equipped).
(15) Lower vehicle.
(16) Fill the crankcase with new engine oil.
(17) Connect the battery negative cables.
(18) Start engine and check for oil leaks.
Hammer
ENGINE 5.9L DIESEL
SOLID LIFTERS/TAPPETS
REMOVAL
NOTE: This procedure requires use of Miller Tool
8502 Tappet Replacement Kit.
(1) Remove camshaft (Refer to 9 - ENGINE/EN-
GINE BLOCK/CAMSHAFT
BLOCK) - REMOVAL).
(2) Insert the trough (provided with tool kit) the
full length of the camshaft bore (Fig. 79). Make sure
the cap end goes in first and the open side faces up
(towards tappets).
(3) Remove only one tappet at a time. Remove
rubber band from one cylinder pair and attach tappet
dowel not being removed to the next cylinder pair
(Fig. 80).
Fig. 79 Inserting the Trough - Typical
1 - TROUGH
Fig. 80 Secure Dowel/Tappet to Adjacent Cylinder -
& BEARINGS
typical
9 - 327
(IN