Trunk; Opening - Chrysler 300 SRT 2019 Owner's Manual

WARNING!
Be sure the hood is fully latched before
driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in
motion and block your vision. Failure to follow
this warning could result in serious injury or
death.
CAUTION!
To prevent possible damage, do not slam the
hood to close it. Lower hood to approximately
12 inches (30 cm) and drop the hood to
close. Make sure hood is fully closed for both
latches. Never drive vehicle unless hood is
fully closed, with both latches engaged.

TRUNK

Opening

The trunk can be opened from inside the vehicle
using the power trunk button located on the
instrument panel to the left of the steering
wheel.
The trunk lid can be released from outside the
vehicle by pushing the trunk button on the key
fob twice within five seconds or by using the
external release switch located on the underside
of the decklid overhang. The release feature will
function only when the vehicle is in the unlock
condition.
With the ignition in the ON/RUN position, the
trunk open symbol will display in the instrument
cluster indicating that the trunk is open. The
odometer display will reappear once the trunk is
closed.
With the ignition in the OFF position, the trunk
open symbol will display until the trunk is closed.
NOTE:
Refer to "Keyless Enter-N-Go — Passive Entry"
in "Doors" in "Getting To Know Your Vehicle" for
further information on trunk operation with the
Passive Entry feature.
Opening From Inside The Vehicle
Interior Power Trunk Release
The trunk
opened from inside the
vehicle using the power
trunk release button lo-
cated on the instrument
panel to the left of the
steering wheel.
Power Trunk Release
NOTE:
The transmission must be in PARK before the
button will operate.
Opening From Outside The Vehicle
To Unlock/Open The Trunk
The trunk may be unlocked/opened using either
of the following methods:
• Key Fob Trunk Release Button
• Passive Entry Button
Key Fob Trunk Release Button
Push the power trunk button on the
key fob twice within five seconds to
release the trunk.
Passive Entry Button
Push the trunk passive entry button which is
located on the back of the trunk lid. With a valid
Passive Entry key fob within 5 ft (1.5 m) of the
trunk, push the passive entry button to open the
can be
trunk.
Trunk Passive Entry Button
59