Pto Clutch Pack And Holder; Solenoid Valve (Pto); Removing Solenoid Valve Assembly; Pto Clutch Pack - wsm M6040 Workshop Manual

M6040, M7040, WSM

[10] TRANSMISSION CASE

(1) Removing Solenoid Valve Assembly

(2) PTO Clutch Pack

Solenoid Valve Assembly
1. Remove the hydraulic pipe (2) and (3).
2. Remove the solenoid valve assembly (1).
3. Remove the hydraulic pipes (4).
(When reassembling)
• Apply transmission fluid to the O-rings.
• Apply liquid gasket (Three Bond 1206C or equivalent) to the
joint face.
Joint screw for hydraulic
Tightening torque
pipe
(1) Solenoid Valve Assembly
(2) Hydraulic Pipe (2WD)
Removing PTO Clutch Pack and Holder
1. Pull out the pin (2) with sliding hammer (3). (see page G-65.)
2. Take out the hydraulic pump drive gear (1).
3. Remove the PTO clutch holder mounting screws.
4. Remove the PTO clutch (4) with holder (5).
(When reassembling)
PTO clutch holder
Tightening torque
mounting screw
(1) Gear
(2) Pin
(3) Sliding Hammer
3-S41
TRANSMISSION
29.4 to 34.3 N·m
3.0 to 3.5 kgf·m
21.7 to 25.3 lbf·ft
(3) Hydraulic Pipe (4WD)
(4) Hydraulic Pipe
9Y1210143TRS0069US0
23.5 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(4) PTO Clutch
(5) Holder
9Y1210143TRS0070US0
KiSC issued 07, 2012 A